A dryer that won’t heat or won’t spin turns laundry day into a week-long project. Best Pro repairs gas and electric dryers of all major brands across Denver and the surrounding area, including stacked and laundry-center units, usually on the same day you call.
Runs but doesn’t heat
- Electric dryers: a burned-out heating element, a blown thermal fuse or high-limit thermostat, or a failed cycling thermostat. An electric dryer needs both legs of its 240-volt circuit: the drum can turn on one leg while the heater gets nothing, so we check the outlet and the breaker before blaming the dryer.
- Gas dryers: a weak igniter, failed gas valve coils, a flame sensor or the same thermal fuse. If the igniter glows but the flame never lights, or lights and goes out, the gas valve coils are a common cause.
A blown thermal fuse is usually a symptom, not the cause: it trips because the dryer overheated, most often because the vent is clogged. Replacing the fuse without fixing the airflow means it blows again.
Drum doesn’t turn
A broken or slipped drive belt, a worn idler pulley or a failed motor. If the motor hums but the drum doesn’t move, the belt or the pulley is the usual suspect; if nothing happens at all, it can be the door switch, the start switch or the thermal fuse.
Loud noise or squealing
Worn drum rollers, the idler pulley, the drum glides or the rear bearing. A squeal that follows the drum points to rollers or the pulley; a rhythmic thump can be a flat spot on a roller — or a shoe in the drum.
Takes too long to dry
Often the dryer itself is fine and the vent is the problem: lint packed in the duct, a duct crushed behind the dryer or a blocked outside hood. A long or kinked vent run makes the dryer work harder, overheat and trip its safety fuses. We check the airflow as part of every dryer diagnostic, and our dryer duct cleaning service clears the vent.
Shuts off mid-cycle
A motor overheating and tripping its internal overload, a failing moisture sensor or timer, or a control board fault.
How we work
Our technicians find the actual cause before replacing anything, so you don’t pay for parts you don’t need. You approve the price before we start, and the repair comes with a 90-day warranty on parts and labor. For laundromats, hotels and other businesses, see commercial dryer repair.
Common problems we fix
- Not heating
- Takes too long to dry
- Drum not spinning
- Won’t start
- Loud noise or squealing
- Shuts off mid-cycle
- Overheating
- Burning smell
How much does dryer repair cost in Denver?
Every visit starts with a diagnostic. The service call is $85, and it is included in the repair price if you go ahead with the repair. Labor for dryer repair is typically $185–$425, plus parts.
A thermal fuse, belt or igniter is a smaller repair; a motor or a control board costs more.
You approve the price before we start, and the repair comes with a 90-day warranty on parts and labor. All rates and surcharges are on our prices page.
Thank you!
We got your request and will call you back shortly during business hours (8:00 AM – 10:00 PM).
In a hurry? Call us: (303) 268-5671