A down washer in a laundromat is lost income; in a hotel or a gym it means running out of clean linens. Best Pro repairs commercial washers for laundromats, hotels, gyms, salons, care homes and other businesses with on-premise laundry across the Denver metro area.
Washers we repair
- Front-load and top-load coin and card-operated washers
- Soft-mount washer-extractors that stand on their own suspension
- Hard-mount washer-extractors bolted to a concrete base
- Stacked commercial washer-dryers
Common failures
- Door won’t lock, or stays locked. The door lock is the most frequently replaced part on a busy front-loader. The washer won’t start until the controller sees the door locked.
- Not draining. Many washer-extractors drain by gravity through a drain valve rather than a pump. A stuck valve or a clog in the drain trough leaves water in the drum and stops the extract.
- Out-of-balance shutdowns or violent shaking. Worn shock absorbers or springs on soft-mount machines; loose anchor bolts or a cracked concrete base under hard-mount machines.
- Loud roar during extract. High extract speeds are hard on bearings and seals. Replacing them early prevents damage to the shaft and drum.
- Leaking. A worn door gasket, a drain valve that doesn’t seal, or a failed tub seal.
- Drive fault codes. Most modern washer-extractors run on a variable-frequency drive. We check the motor, the drive and the wiring before replacing anything expensive.
Chemical injection pumps connected to the washer are usually maintained by your chemical supplier; we check the washer side of the connection.
You get the price before any work starts and a 90-day warranty on parts and labor. For your dryers, see commercial dryer repair; for home washers, see washer repair.
Common problems we fix
- Door won’t lock or unlock
- Not draining
- Won’t spin or extract
- Out-of-balance shutdowns
- Leaking from the door or under the machine
- Loud bearing noise during spin
- Not filling
- Motor or drive fault code
How much does commercial washer repair cost in Denver?
Our technician diagnoses the equipment first and gives you a flat price before any work starts. Labor starts at the $185 minimum for any repair, and parts are priced separately because they depend on the make and model.
A door gasket, a drain valve or a clog is a smaller repair; a drive motor, a tub seal and bearings or a control board costs more.
You approve the price before we start, and the repair comes with a 90-day warranty on parts and labor. All rates and surcharges are on our prices page.
Thank you!
We got your request and will call you back shortly during business hours (8:00 AM – 10:00 PM).
In a hurry? Call us: (303) 268-5671
